You are hereLighting / LED Headlight Design - 3+1

LED Headlight Design - 3+1

Rob's picture

By Rob - Posted on 18 October 2006

To overcome the difficulties in the first design (where the bracket holding the LED tubes is wider than the control box) this appeared.

Bolt LEDs to Berocca tubes (hence the green) and then into 20x20x1.5mm aluminium angle. The bottom part (with three tubes) is then fixed and hinged to the transparent box behind (83x54x30mm) which holds the control electronics.

The fourth and final LED is fixed atop the first bracket. Not sure I like this really as it's looking a bit vulnerable to impacts with tree branches.


Best Mountain Bike