MaxFlex Clamp

This is my second attempt at a MaxFlex fitting after realising it should not be attached to the LED holder. After removing the previous effort (very lucky to be able to get a hack saw on it) there was some 3mm aluminium still fixed with Arctic thermal epoxy to the gold section on the MaxFlex. That will be attached to the base of this aluminium here.

The higher part with the gap in will reach around and be fixed to the inductor on top of the MaxFlex. Then the whole thing will be greased and screwed to outer case for heat sinking. TaskLED support say under 'certain' conditions the inductor needs a sink but don't have time to mess about so decided to err on the side of caution.