You are here
SquidLED
Dual SquidLED
The slight patch of grey seen on the left of the top connecting tube is where metal epoxy (Arctic Alumina) squeezed out. Aside from that the external finish is very good.
SquidLED Front/Rear
The thick black wire on the right there is nothing to do with the design... it's just there to balance them at the same height (due to switch/socket on back of the other side of that set).
SquidLED Internals
All wired and ready for light head installation.
I wired this with solid core CAT5 inner which should be fine for signal wire and current to LEDs (700mA tops). However, the input current draw could be over twice that so there are 2 cores from the power socket to controller. Just in case you're counting the wires and spotting 2 too many.